Most purchases from business sellers are protected by the Consumer Contract Regulations 2013 which give you the right to cancel the purchase within 14 days after the day you receive the item. The Fan QF120 LED has extraordinarily quiet bearings so that the noise level of the entire cooler is low 25 dB (A). The standard Cryorig H7 plus setup features two QF120 balance fas with dimensions of L120 mm x W120 mm x H25. I would first like to thank ASUS, InWin, Patriot, and Fractal Design for supplying products for me to test with.

It also offers the Cryorig name at the top, a blue box explaining the design near the bottom, and a notation of aspects that make it more efficient, while still offering a fair bit of style. The Fan QF120 has an extraordinarily quiet bearing itself, so that the noise level of the entire cooler is low 25 dB (A). With solid material choices of copper, nickel-plating, and aluminum, the H7 Quad Lumi is not a whole lot of difference from other heatsinks.Cryorig H7 plus is designed and equipped with a perfectly milled C1100 pure copper nickel coated contact plate with dimensions of 40 x 45 mm holding in line the 3 x Ø6mm nickel coated copper heat pipes arranged according to the Convex-Align™ system. As an effective anti-vibration measure four rubber dampers are embedded in the corners in the 120mm fans. Again, it's not the best showing here, but the H7 still outperformed larger and more expensive options that may not fit where this cooler does. With the fan receiving more voltage, and reporting a speed of 1600 RPM, the noise level does increase to 50 dB, but as you can see, there are much worse coolers out there. The QF120 fan has an exceptionally quiet bearing, so the noise level of the entire cooler is as low as 25 dB (A).

We can see through the open section of the side that the fins are already flat, and that they do close off the majority of the section to keep that 49 CFM inside of the cooler.To keep the tradition, let’s start with the contact plate, which is the component of the heat sink with the most important role for the actual cooling. However, the X-bar allows great access to the screws around it, and no encroachment to the top PCI-e slot either. We are shown the compatibility potential of this design in the seven bubbles at the top of the chart. Not only does this cooler allow for unlimited height to the spreaders, but the cooler and the wire clips are still a few millimeters away, and won't press against the nearest stick.

With the system overclock applied, and the fan running at full speed, we found the H7 does slide down the chart a bit with the 74. On the face of it, it does not look that special, measuring just 145mm tall and utilising a mere 3 heatpipes.This is a bit tricky in practice as you have to flip the motherboard over and then tighten the screws while holding the cooler in-place. Even the ancient Zalman coolers that feel like you're about to snap your motherboard in half aren't as overly complicated as the DRP3.

A+ seller and I asked to have seller send me a feedback revision request since my initial feedback rating is no longer valid. As an effective anti-vibration measure four rubber dampers are embedded in the corners of the 120mm fan. To test all CPU coolers, we devised an easily repeatable test with no variables other than the coolers themselves. With taking the cooler in my hand for first time I spent some time enjoying the cooler’s structure and according to what I saw the cooler is designed with all of the features included in the big brothers in the company portfolio and that includes the Hive Fin structure, Jet Fin Acceleration System and asymmetrical fins stack combined with Quad Air Inlet provided by the fan. Read more about the condition Opened – never used: An item in excellent, new condition with no wear.Of course this was done because at the time of its release CRYORIG didn't have an RGB fan (that should change in a month or so) but as you will see later on this fan/LED strip combination (adjustable by an NZXT CAM controller built-in the cooler - CRYORIG should release their very own solution soon) looks very nice. By checking all of the accessories, I can say that every single part of this package is carefully chosen so the cooler can deliver maximum compatibility and a lot of options. CRYORIG has only been a part of the cooling market for a short while, but the company already has an extensive lineup of CPU coolers and fans, and they have quickly made a name for themselves with the R1 Ultimate and R1 Universal.